Filter
Top Products
Ridge Tool Company
24
Then use the Up and Down Keys to scroll through the
available frequencies. Highlight the desired frequency to
add it to the Activated Frequencies list
(Figure 43)
.
Figure 43 – Highlighting a Frequency to Activate
Checking a frequency (using the Select Key) will include
it in the selected frequencies on the Main Menu. Once on
the Main Menu it can be set to checked-active status, and
then be chosen using the Frequency Key.
Figure 44 – Selecting a Frequency to Activate
To switch to a “currently available” frequency that is not yet
“Checked-Active”, press the Menu Key and scroll
down to the desired frequency; if it is not checked, press
the Select Key to toggle the checkbox to “checked”. This
sets the status of that frequency to “Checked-Active”.
Press the Menu Key to return to the operating display,
which will now be set to the frequency just activated.
The NaviTrack II will show the chosen frequency and its
icon on the left of the screen as the current “in-use” fre-
quency.
“Checked-active” frequencies can be switched while the
NaviTrack II is in use, by pressing the Frequency Key.
When using the Frequency Key, the NaviTrack II will
cycle down through the set of active frequencies from low
to high, group by group, and repeat. Unchecking a fre-
quency in the Main Menu will de-activate it, and then it will
not appear when pressing the Frequency button.
NOTE! If a frequency appears missing, look to make
sure it is in the Main Menu frequencies list. If it
is present but unchecked, set it to “Checked-
Active” status by highlighting it and pressing
the Select Key. If it is not present, go to the
Frequency Selection menu and the appropri-
ate sub-category and select it there, checking
the box to make it currently available in the
Main Menu list. Make sure it is “checked” at
both menu levels for it to appear in the current
working set of frequencies.
Information Screen and Restoring
Defaults
Information Screen
The information screen appears at the bottom of the
Main Menu. Highlighting the Information icon and press-
ing the Select button displays information about the lo-
cator, including software version, serial number of the
receiver and its calibration date.
Figure 45 – NaviTrack II Information Screen
Restore Factory Defaults
Pressing the Select Key a second time will display the
Restore Factory Defaults option.
Figure 46 – Factory Defaults Selection
This option is turned on by selecting the checked box (√).
If the “X” option is chosen, no change from current set-
tings will be made.
NaviTrack
®
II