Radware VOYA-GRAND-PMH Lawn Mower User Manual


  Open as PDF
of 56
 
September 25, 2012
7075-166
Page 43
VOYAGEUR GRAND Wood Insert
R
I. Blower Cord Installation on Left Side
Theblowercordisshippedtobeinstalledontherightside
oftheappliance.Youmayrelocatethecordsoitisonthe
left side.
Overview: You are removing the power cord from the
blower controls, re-routing the cord to the left side and re-
installing the power cord to the blower controls. Refer to
the exploded drawing on page 44.
1. Remove contents from box being careful not to scratch or
damage the cast trim pieces.
2. Lay surround pieces face down on a protected surface to
prevent scratching.
3. Alignthebossesonthetoppiecetotheholesontheside
pieces.Securethe3piecestogether.
4. Attachthemountingbracketstothesidepiecesincludedwith
thekit.Figure 43.1.
5.
In order to get a tight seal for the surround, you must reposition
asideshield.Therearetwoholesontheshieldanditwillcome
fromthefactorysecuredintherst(left)hole.Removethe
shieldandre-installusingthesecond(right)hole.Figure43.2.
5. Position the trim on the appliance matching up the mounting
bracketswiththeslotsontheappliance.
6. Attachthesurroundtotheappliance2screws.
DO NOT OVERTIGHTEN SCREWS - MAY DAMAGE
PROCELAIN FINISH.
Included in Surround Kit:(2)sidepieces,leftandright;(1)
ltoppiece;(1)fastenerpackage.
Tools Needed: Powered 4 to 6 inches long Phillips head
screwdriver;pliers
H. All Cast Surround Kit
4 Mounting Brackets
Mounting
Brackets
Attach to Appliance
with Screws
Remove and Reposition
Side Shield using Second
Hole
Do not overtighten - may
damage porcelain finish
Figure 43.1
Figure 43.2
1. Swingthegrilledowntoexposethe2bolts,one
at each end. Remove the bolts and pull blower
access assembly away from appliance and store
awayfromyourworkarea.
2. Removethe2screwsintheholddownbracketin
frontoftheblowerassembly.Youdonotneedto
removetheblowerfromtheholddownbracket.
3. Disconnect the 2 blower wires that are attached
to the wire harness and pull the blower assembly
away from the appliance.
Figure 43.3
Figure 43.4
Size:40in.Wx30in.H
 previous next