A SERVICE OF

logo

Open as PDF
next previous
Page 42
7075-166
September 25, 2012
R
VOYAGEUR GRAND Wood Insert
1. Remove contents from box being careful not to scratch or
damage the cast trim pieces.
2. Lay surround face down on a protected surface to prevent
scratching.
3. Usinga4to6incheslongPhillipsheadscrewdriverattach
the side surrounds to the top surround using (2) #8 sheet
metalscrewsoneachsideprovidedwiththekit
4. Placethepeelandstickroundfeltvibrationinsulationpads
on the front side in each corner of the top metal piece and
onthebacksideineachcornerofthetopcastpiece.Figure
42.1.
5. Place the corresponding cast trim pieces (2 cast trim sides
and 1 cast trim header) underneath the panel set, also face
down.Aligntheholesinthemetalpieceswiththe5bosses
on the top cast piece and 2 bosses on each side piece.
6. Securethemagnettothebracketandattachthemagnetand
brackettoeachmetalsidepieceatthebottom.Themagnet
is facing the front. Figure 42.2.
Included in Surround Kit:(2)sidepieces,leftandright;(1)
ltoppiece;(1)fastenerpackage.
Included in Cast Trim Kit:
(2)casttrimlegs,leftandright;
(1)casttrimheader;(2)casttrimfooters,leftandright;(1)
fastenerpackage.
Tools Needed: Powered 4 to 6 inches long Phillips head
screwdriver;pliers
G. Standard Surround & Cast Trim Kit
(4) Felt Vibration Insulation Pads
Secure
Surrounds to
Cast Trim Kit
Attach Magnet
before installing
Cast Footers
Magnet Installed
Cast Footers,
Left & Right
Figure 42.1
Back
of
Side
Piece
Magnet Attached - Faces Front
Clearance Notch
7. Place the cast footers under the metal sides aligning the top
and bottom holes in the cast footers and metal sides.
8. The9mountingclipsareshippedinonelongstrip.Hand
breakapartorusepliers.
9. Eachcliphasaclearancenotchtoallowroomforthecast
on the insert. Place the clip so the notch is facing the outer
edges of the surrounds. Figure 42.3.
10.Itisbesttoinstallallofthe1/4-20screwsonlyhalfwayat
rsttoallowforadjustments.Afteradjustment,tightenthe
2screwsineachcastfooterrstandthenworkyourway
around to the rest.
11.Slidesurroundandtrimoverthetopoftheinsertintoplace
matching the mounting tabs on the metal sides with the slots
on the insert. Figure 42.4.
12.Alignthe2screwsinthetopmetalsurroundpiecetothe
2alignmentholesontheappliancetop.Secureinplace.
Figure 42.4.
Figure 42.2
Figure 42.3
Match Mounting
Tabs to Slots on
the appliance
Figure 42.4
StandardSize:42-1/2in.Wx30in.H
LargeSize:48in.Wx34in.H