Filter
Top Products
D200
Using the D200 built-in flash as a com-
mander, the exposure compensation is con-
trolled within the Commander Mode menu.
In this menu, you choose the group and
make the changes with the camera. The
menu enables you to adjust the exposure of
the built-in Speedlight, and Groups A and B
individually.
You can also make changes globally by
pressing the Flash button on the camera
body and using the front command dial.
When using this method, the change is
applied to all groups including the built-in
Speedlight.
SB-800
First you must set the SB-800 to act as a
master flash in the CSM. When in the Master
Flash menu, use the SEL button to cycle
between groups. After you have the proper
group highlighted, use the + or – buttons to
adjust the exposure up and down.
SU-800
To adjust flash exposure using the SU-800
as a commander, first use the toggle switch
to set the SU-800 in Commander mode. The
switch is located next to the battery com-
partment. The toggle switch changes
between close-up and commander func-
tions. Press the SEL button to select the
Flash mode. After the Flash mode is
selected, press the Mode button. Press the
Select button again to highlight the expo-
sure compensation for each group. Use the
left and right arrows to increase or decrease
exposure.
40 Part I ✦ Using the Creative Lighting System
2.3 The SU-800 on camera
07_045275 ch02.qxp 11/28/06 8:24 PM Page 40