Filter
Top Products
1 Service
14
Parameter table (continued)
Table 1D_(continued from previous page) This table lists SMART SYSTEM control module parameters and where to
access them
Menu
Sub
Item
Description
See
Page
User Access Installer Access
Display Modify Display Modify
G
1 Anti-cycle Delay 19 No No Yes Yes
2 Anti-cycle Override Differential 19 No No Yes Yes
3 Min On/Off Time Stages 1, 3 19 No No Yes Yes
4 Delay Between Stages 1, 3 19 No No Yes Yes
H
1 Controlling Sensor 20 No No Yes Yes
2 Enable Input (Active / Inactive) 20 No No Yes Yes
3 BMS Input (Active / Inactive) 20 No No Yes Yes
4 Cascade (Active / Inactive) 20 No No Yes Yes
5 Sequencer 20 No No Yes Yes
6 ModBus (Active / Inactive) 20 No No Yes Yes
7 ModBus Timeout 20 No No Yes Yes
I
1 Cascade Address 21 No No Yes Yes
2 Max. Outlet Set point 21 Yes Yes Yes Yes
3 Cascade Offset 21 No No Yes Yes
4 Cascade Differential 21 No No Yes Yes
J
1 BMS Type 21 No No Yes Yes
2 Voltage at Minimum 21 No No Yes Yes
3 Voltage at Maximum 21 No No Yes Yes
4 Power at Low Voltage 21 No No Yes Yes
5 Power at High Voltage 21 No No Yes Yes
6 Setpoint at Low Voltage 21 No No Yes Yes
7 Setpoint at High Voltage 22 No No Yes Yes
8 Voltage to Start CFH 22 No No Yes Yes
9 Voltage Differential CFH 22 No No Yes Yes
K
1 System Pump Delay 22 No No Yes Yes
2 Boiler Pump Delay 22 No No Yes Yes
3 DHW Pump Delay 22 No No Yes Yes
4 System Pump Mode 22 No No Yes Yes
L
1 Service Calendar Time (months) 22 No No Yes Yes
2 Service Run Time (hours) 22 No No Yes Yes
3 Service Cycles 22 No No Yes Yes
4 Reset Service Reminder 22 No No Yes Yes
5 Personality Plug 22 No No Yes Yes
ANTI-
CYCLING
CONTROL
MODES
CASCADEBMSPUMPS
SERVICE
NOTIFICATION
Copper-fin II/IIE Boiler, Water Heater and Pool Service Manual