Filter
Top Products
19
Section 4: Operating Procedures
5/21/07
RBT55120 Rear Blades 301-172M
Land Pride
Table of Contents
General Operating Instructions
Once you have familiarized yourself with the Operator’s
Manual, completed the operations checklist, and
properly attached your Land Pride Rear Blade to your
tractor, you are now almost ready to begin work. The
RBT55 Series Rear Blades were designed and built by
Land Pride for category lI and lII three-point hitch and
Quick Hitch attachment for 90 to 180 hp tractors
equipped with remote hydraulic outlets and two wheel
drive capability. They are ideal for snow removal as well
as dirt leveling, finish grading, and backfilling
applications at feedlots, outdoor arenas, building and
construction sites, and maintenance operations on farm
and ranch lanes or roadways. They are also excellent for
soil contouring and construction and maintenance of
ditches and waterways.
Hopefully you have checked out your work site for any
buried utility cables, pipelines, sprinkler heads, or other
obstacles that you wouldn’t want to damage or
encounter. Grade stakes should now be in place if you
intend to develop a specific grade, elevation, soil
contour, or roadbed crown. A RBT55 Series Rear
Blade’s primary purpose is for grading or leveling of soil,
gravel, or aggregate in the warmer months or snow
removal in the colder months. These functions are best
done at an approximate 2 to 4mph ground speed.
Becoming proficient with a Rear Blade takes practice.
Tractor horsepower, your personal skill level, soil or
aggregate composition, moisture levels, and compaction
factors will all have a definite impact on how easily and
effectively you get the job done when you are in the dirt
working mode. Develop a plan to achieve your expected
results. Set the blade up at the proper angle or angles to
do the job. The hydraulic angling, tilt, and offset
capabilities of the RBT55 series will make these
adjustments easy utilizing the tractors remote hydraulic
controls. This may require some experimentation to
achieve the desired results. Lower the blade to the
ground and proceed forward at a speed of no more than
2 to 4 mph. The blade should immediately begin shaving
the soil surface and dirt or aggregate material. Set the
tractor’s draft-link height control in the desired position.
With the blade set at a 90 degree angle you may need to
raise the blade slightly so that the dirt or gravel can flow
out evenly under the blade effectively shaving off high
spots and filling in potholes or depressions.
If you have the blade set at a horizontal angle, the
shaved or accumulated material will begin to move
outward toward the trailing edge of the blade. The
greater the angle the more quickly the shaved material
will be distributed off to the side. If it is necessary to work
up next to a building foundation, abutment, or raised curb
you may want to offset the blade so that the outside edge
of the blade is beyond the outer edge of the tractor tire in
working position. Back-filling operations may be more
easily performed by reversing the blade and operating
the tractor in reverse or commonly called the push mode.
If you are performing the construction of soil contours or
waterways you will probably need to set a tilt angle on the
blade to achieve the desired effect. If you are grading or
cutting a new ditch bank or forming a road crown, you will
probably want to offset the blade in combination with
setting an appropriate tilt angle. This again will likely
require some experimentation to gain desired results.
Snow removal techniques with a blade will be very
similar to dirt working techniques and will require a little
experimentation to become proficient.
With a little practice you should become a very good
operator and consistently achieve the desired results
you expect with your Land Pride RBT55 Series Rear
Blade.
See “Section 6: Specifications & Capacities” on page
23 and “Section 7: Features & Benefits” on page 24 for
additional information and performance enhancing
options.