Filter
Top Products
11
Section 2: Options, Assembly & Set-Up
5/21/07
RBT55120 Rear Blades 301-172M
Land Pride
Table of Contents
Blade Tilting Cylinder
Refer to Figure 2-3:
1. Install two 90 degree elbows (#4) into the hydraulic
cylinder ports (#3) as shown. Tighten as needed.
IMPORTANT: Do not remove shipping block from
the blade tilt housing until all cylinders and/or ratchet
jack and manual links have been installed.
IMPORTANT: Assemble base end of cylinder to the
lug located on the blade pivot as shown.
2. Screw 140" long hydraulic hoses (#5) into
elbows (#4) and tighten.
3. Thread adapter fittings (#6) to the other end of the
hydraulic hoses and tighten.(Hydraulic couplings not
furnished.)
4. Attach hydraulic cylinder (#3) to the lugs at the back
of the blade with clevis pins (#2). Make sure
hydraulic ports are positioned on the back and the
cylinder base is mounted to the center lug as shown.
5. Secure clevis pins with hair pin cotters (#1).
6. Remove shipping block at this time.
Hydraulic Blade Tilting
Figure 2-3
SHIPPING BLOCK
DO NOT REMOVE UNTIL AFTER ALL
HYDRAULIC CYLINDERS AND/OR
RATCHET JACK AND MANUAL LINKS
HAVE BEEN INSTALLED.
25504