Filter
Top Products
9
Section 1: Assembly & Set-Up
5/21/07
RBT55120 Rear Blades 301-172M
Land Pride
Table of Contents
Tractor Hook-Up
Refer to Figure 1-2 & Figure 1-3:
!
DANGER!
Tractor hook-up to equipment is dangerous and can result in
serious injury or death. Do not allow anyone to stand between
the blade and tractor during hook-up operations. Do not
operate the hydraulic 3-point lift controls while someone is
directly behind the tractor or near the blade.
1. Slowly back tractor up to the 3-Way Rear Blade while
using the tractor’s 3-point hydraulic control to align
the lower hitch link holes with lower hitch clevis holes
on the Rear Blade.
2. Engage tractor park brake, shut tractor engine off
and remove key before dismounting from tractor.
3. With tractor’s lower hitch arms aligned and
positioned in the clevises, insert hitch pins through
the clevis lugs and lower arm holes. Be sure to use
the bushings as shown in Figure 1-3. Secure hitch
pins with linch pins.
4. Connect top center link to the upper pivot hitch
mounting holes using customer supplied clevis pin
and linch pin.
5. Ensure that the lower hitch arms are blocked to
prevent excessive side movement.
6. Remove hitch pin and raise support stand fully up.
Reinsert hitch pin and secure with lock pin.
7. Return to the tractor and slowly operate controls up
and down to check for clearance. Make certain the
Rear Blade does not interfere with the tractor hitch,
tires, and drawbar. Move or remove the drawbar if it
interferes.
8. Manually adjust one of the two lower lift arms up or
down to level the Rear Blade from left to right.
9. Manually adjust length of the top-link to level the
Rear Blade from front to rear.
Tractor 3-Point Hitch
Figure 1-2
23998
Lower 3-Point Hitch Setting
Figure 1-3
12864
Category ll
Standard & Quick Hitch
Category ll
Standard Hitch
Category lll
Standard & Quick Hitch