Filter
Top Products
17
Section 3: Adjustments
5/21/07
RBT55120 Rear Blades 301-172M
Land Pride
Table of Contents
Refer to Figure 2-3 on page 11:
The blade end can be tilted hydraulically with the tilt
cylinder by as much as 30 degrees.
1. If the tilting cylinder is attached to the selector valve,
make certain the valve lever is set to operate that
cylinder.
2. Operate tractor control lever to change blade tilt by
as much as 30 degrees.
Gauge Wheel
Refer to Figure 2-5 on page 13:
The gauge wheel provides accurate depth control when
grading, leveling or terracing. The height of the gauge
wheel is determined by adjusting the ratchet jack or
hydraulic cylinder.
Manual Gauge Wheel Adjustment
1. Set ratchet lock and pump lever back and forth to
raise the gauge wheel.
2. Reposition ratchet lock and pump lever back and
forth to lower gauge wheel.
Hydraulic Gauge Wheel Adjustment
1. If the gauge wheel cylinder is attached to the selector
valve, make certain the valve lever is set to operate
that cylinder.
2. Operate tractor control lever to change gauge wheel
height up or down.
IMPORTANT: The top center 3-point link can be
removed from both the blade and tractor before
using the gauge wheel accessory with the blade.