Filter
Top Products
10
Section 2: Options, Assembly & Set-Up
RBT55120 Rear Blades 301-172M
5/21/07
Land Pride
Table of Contents
Section 2: Options, Assembly & Set-Up
Blade Offset Cylinder
Refer to Figure 2-1:
Assemble the hydraulic hoses to the hydraulic cylinder
before placing the cylinder on the blade.
1. Position hydraulic cylinder (#3) with ports on top as
shown. Install two straight fittings (#4) into the
cylinder ports as shown. Tighten as needed.
2. Screw 116" long hydraulic hoses (#5) into
straight fittings (#4) and tighten.
3. Thread adapter fittings (#6) to the other end of the
hydraulic hoses and tighten.(Hydraulic couplings not
furnished.)
4. Attach hydraulic cylinder to the lugs located on the
left side of the 3-Way Rear Blade with clevis pins
(#2). Make sure hydraulic ports are positioned on top
and the cylinder base in positioned to the front as
shown.
5. Secure clevis pins with hair pin cotters (#1).
6. Route hoses through hose bracket located on the
right side of the front hitch. Connect hoses to
tractor's hydraulic system.
Hydraulic Blade Offsetting
Figure 2-1
IMPORTANT: Do not remove shipping block from
the blade tilt housing until all cylinders and/or ratchet
jack and manual links have been installed.
IMPORTANT: Attach cylinder base to the front hitch
lug. The cylinder base will interfere with the main
frame if attached to the rear lug.
25502
Blade Angling Cylinder
Refer to Figure 2-2:
1. Position hydraulic cylinder (#3) with ports on top as
shown. Install two straight fittings (#4) into the
cylinder ports as shown. Tighten as needed.
2. Screw 116" long hydraulic hoses (#5) into
straight fittings (#4) and tighten.
3. Thread adapter fittings (#6) to the other end of the
hydraulic hoses and tighten.(Hydraulic couplings not
furnished.)
4. Attach hydraulic cylinder to the lugs on the right side
of the frame with clevis pins (#1). Make sure
hydraulic ports are positioned on top and the cylinder
base in positioned to the front as shown.
5. Secure clevis pins with hair pin cotters (#2).
6. Route hoses through hose bracket located on the
right side of the front hitch. Connect hoses to
tractor's hydraulic system.
Hydraulic Blade Angling
Figure 2-2
IMPORTANT: Do not remove shipping block from
the blade tilt housing until all cylinders and/or ratchet
jack and manual links have been installed.
IMPORTANT: Attach cylinder base to the front hitch
lug. If attached to the rear lug, the base will interfere
with the main frame.
25503