Filter
Top Products
27
Section 5: Maintenance & Lubrication
9/24/08
RCR2684 Rotary Cutter 312-785M
Land Pride
Table of Contents
Lubrication
Tailwheel Spindle Tube
Type of Lubrication: Multi-purpose Grease
Quantity = 6 pumps
13753
Tailwheel Hub
The tailwheel hub is equipped with a relief hole located
directly opposite the grease fitting. The relief hole
releases pressure from inside the hub casting when it
is greased. The hub should be greased until grease
purges from the relief hole.
Type of Lubrication: Multi-purpose Grease
Quantity = Until grease purges from the relief hole
13753
Gearbox
Oil expands when hot, therefore, always check oil level
when cold. Unscrew top vent plug in gearbox to remove
dipstick. Wipe oil from dipstick and screw it back in without
tightening. Unscrew dipstick and check oil level mark. If
low, fill through top plug hole in gearbox with gear lube until
oil reaches full mark on the dipstick. Reinstall vent plug with
dipstick and tighten.
Type of Lubrication: 80-90W EP Gear Lube
Quantity = Fill until oil reaches full mark on dipstick.
NOTE: Do not overfill! Cutter should be level when
checking oil. Oil should be cool not hot.
NOTE: The cutter is equipped with an air vent plug
with dipstick. Some cutters are shipped with vent
plug strapped to the brace bar and others are
shipped with vent plug installed in the gearbox.
Please see your dealer if you did not receive a vent
plug with dipstick.
50
Multi-purpose
spray lube
Multi-purpose
grease lube
Intervals in hours
at which lubrication
is required
Lubrication
Legend
Multi-purpose
oil lube
8
Hours
24
Hours
8
Hours
2459