Filter
Top Products
16
Section 2: Adjustments
RCR2684 Rotary Cutter 312-785M
9/24/08
Land Pride
Table of Contents
Single Tailwheel Height Adjustment
Figure 2-3
14388
Cutting Height
Figure 2-4
20947
Front
Blade
Rear
Blade
For best cutting efficiency, adjust the
lower 3-point arm height such that the
front cutter blade is approximately 1"
lower than the rear cutter blade.
Cutter Height Adjustment
Single Tailwheel
Refer to Figure 2-3:
If the cutting height is too high or too low, the tailwheel
must be adjusted as follows:
1. Use tractor’s 3-point hydraulic control to lift the
tailwheel off the ground.
2. Remove attaching hardware; 1/2” -13 x 1 1/2" GR5
hex head bolt (#1), 1/2” lock washer (#2) and 1/2” nut
(#3).
3. Adjust tailwheel up or down to desired cutting height
by repositioning adjusting plate (#4) and replace
attaching hardware.