Filter
Top Products
10
Section 1: Assembly and Set-up
RCR2684 Rotary Cutter 312-785M
9/24/08
Land Pride
Table of Contents
Check Chain Installation (Optional)
Refer to Figure 1-5:
1. Install lower end of check chain (#1) to inner hitch ear
using 3/4”-10 x 1 1/2” GR5 hex head bolts (#2), lock
washers (#3) and nuts (#4). Tighten securely.
2. Install chain lugs (#5) on either side of tractor top link
mount using 1” Dia. pin for Category II and 1 1/4” for
Category III (pin not supplied).
3. Cutting height is then set by placing proper chain link
in key slot (#5).
Front and Rear Safety Guard Options
!
DANGER
Rotary cutters have the ability to discharge objects at high
speeds; therefore, the use of front and rear safety shields is
strongly recommended when cutting along highways or in an
area where people may be present.
Front Safety Guard
Refer to Figure 1-5:
Install each segment of the front chain or rubber
guards (#1) with 1/2” -13 x 2 3/4” GR5 carriage bolts (#2)
and lock nuts (#3). Tighten all nuts and bolts to correct
torque. See “Torque Values Chart for Common Bolt
Sizes” on page 32.
Rear Chain Guard
Refer to Figure 1-6:
Install each segment of the rear chain guards (#1) as
shown with 1/2” -13 x 1 1/2” GR5 carriage bolts (#2), 1/2”
flat washers (#3) and 1/2” lock nuts (#4).Tighten all nuts
and bolts to correct torque. See “Torque Values Chart
for Common Bolt Sizes” on page 32.
IMPORTANT: Not all objects will be stopped by
safety shields. Therefore, Land Pride recommends
using extreme caution when cutting in public areas.
It is best to operate the Rotary Cutter when no one
is around the cutter.
IMPORTANT: If used, rear chain guards should be
installed before installing tail wheel(s). Guards are
sandwiched between the deck and tailwheel
adjusting brackets.
Optional Check Chain Assembly
Figure 1-4
Front Guard (Chain Guard Shown)
Figure 1-5
.
Rear Chain Guard
Figure 1-6
26635
14382
14383