Filter
Top Products
28
Section 3: Operating Instructions
RCF2784 Rotary Cutters 326-364M
12/15/15
Table of Contents
You will need to maintain 540 RPM PTO speed and 2 to
5 mph ground speed to produce a clean cut. Make a
tractor gear and range selection that will enable you to
maintain these speed combinations. Generally the
quality of cut is better at lower ground speeds. Dense
ground cover will create the need to slow down even
more. In certain conditions tractor tires will roll grass
down resulting in an uneven cut when the grass fails to
rebound. Should this happen you may try reversing the
direction of cut and/or double cut to achieve the desired
finish. Avoid very low cutting heights especially on
extremely uneven terrain. Always cut downward on
slopes and avoid crossing the face of steep slopes. Avoid
sharp drops and cross diagonally through dips to prevent
hanging up the tractor and cutter. Slow down in turns.
Remember to look back often.
Now that you’re prepared and well briefed you may begin
cutting. Begin by doing the following:
• Reducing tractor’s engine rpm.
• Make sure cutter is on the ground in cutting position
and then engage PTO.
• Raise engine rpm to the appropriate 540 PTO speed
and begin cutting.
Make wide turns when possible. 3-Point hitch and
optional Quick Hitch models can be lifted into transport
position to make tight turns and to reverse direction. Try
increasing or decreasing ground speed to determine the
effect on quality of cut. With a little practice you will be
pleased with what your Land Pride Rotary Cutter can do.
Whether you are done mowing, need to take a break, or
just need to make a few adjustments to the cutter,
remember to always do the following:
• Reduce tractor’s engine rpm and disengage PTO.
• Stop on level ground, set park brake, turn off engine
and remove switch key.
• Stay on the tractor until the cutter blades have come to
a complete dead stop.