Filter
Top Products
11
Section 1: Assembly & Set-up
12/15/15
RCF2784 Rotary Cutters 326-364M
Table of Contents
3-Point Dual Tailwheel Option
Refer to Figure 1-4:
1. Attach tailwheel frame (#1) to outside of rear deck
lugs with 5/8"-11 x 1 3/4" GR5 cap screws (#3), and
hex flange nylock nuts (#7). Draw nylock nut up snug,
do not tighten.
2. Install two 2 1/4" OD machine washers (#9A & #9B)
onto tailwheel spindle (#11).
3. Insert tailwheel spindle (#11) into pivot tube of
tailwheel frame (#1) and install machine washer
(#9C) over tailwheel spindle. Secure tailwheel with
3/8" x 2 1/2" roll pin (#10).
4. Attach bottom hole of tailwheel adjustment bar (#2) to
deck rear with 5/8"-11 x 2" GR5 cap screw (#4A), and
hex nylock nut (#6). Draw nylock nut up tight, do not
torque tight.
5. Attach tailwheel adjustment bar (#2) to tailwheel (#1)
with 5/8"-11 x 2" GR5 cap screw (#4B), spring lock
washer (#8), and hex nut (#5). Tighten hex nut until
lock washer (#8) is squeezed flat.
Dual Tailwheel Assembly
Figure 1-4
33267