Filter
Top Products
10
Section 1: Assembly & Set-up
RCF2784 Rotary Cutters 326-364M
12/15/15
Table of Contents
3-Point Single Tailwheel Option
Refer to Figure 1-3:
1. Attach tailwheel A-frame (#1) to inside of rear deck
lugs with 5/8"-11 x 2" GR5 cap screws (#2A), and hex
nylock nuts (#5). Draw nylock nut up snug, do not
tighten.
2. Install two 2 1/4" OD machine washers (#6A & #6B)
onto tailwheel spindle (#9).
3. Insert tailwheel spindle (#9) into pivot tube of
A-frame (#1) and install machine washer (#6C)
over tailwheel spindle. Secure tailwheel with
3/8" x 2 1/2" roll pin (#8).
4. Attach bottom hole of tailwheel adjustment bar (#3) to
deck rear with 5/8"-11 x 2" GR5 cap screw (#2C), and
hex nylock nut (#5). Draw nylock nut up tight, do not
torque tight.
5. Attach tailwheel adjustment bar (#3) to A-frame (#1)
with 5/8"-11 x 2" GR5 cap screw (#2B), spring lock
washer (#7), and hex nut (#4). Tighten hex nut until
lock washer (#7) is squeezed flat.
Single Tailwheel Assembly
Figure 1-3
33266