Filter
Top Products
51
Section 6: Specifications & Capacities
ZSR54, & ZSR60 Accu-Z Razor
®
Zero Turn Mowers 357-344M
Table of Contents
12/15/15
Tire-to-tire width: 48"
Overall Height Top of folded ROPS
Top of unfolded ROPS
50 1/4"
70 1/4"
Certified ROPS Standard
Drive Tires 5-bolt, 20 x 10 -10 Turf Tread
Front Tires 13 x 5 - 6, Ribbed tread with roller bearings
Hour Meter Standard equipment
Fuel Capacities 12 US GAL
Steering Type Hydrostatic Twin lever steering provides independent control of each drive wheel.
Twin Lever Steering Controls Speed, forward, reverse, brake, and turns.
Steering Turning Radius True zero degree. Turns with counter-rotating independent drive wheels.
Brake Service Hydrostatic dynamic braking.
Park Brake Type Manual activated over-center lever to pawl over cog wheel.
Ground Speed
Forward: 0-7.2 MPH
Reverse: 0-4.5 MPH
Motor Drive Single V-belt with electric clutch and manual take-up idler pulley.
Wheel Drive High torque piston type planetary reduction motors
Electrical Operated Logic-Control
Safety Features
Electric logic-control system governs blade engagement, forward & reverse motion,
engine starting & running, and parking brake functions.
Evaporative Emission Control
System on EPA Compliant Mowers
This equipment uses a sealed fuel system which incorporates a non-vented fuel cap.
Evaporative emissions are vented to the engine where they combust during normal
engine operation.
Seat Options Deluxe cushion seat with arm rests.
Mainframe Construction Welded steel
Front Caster Wheels Free turning with greasable roller bearings.
Front Caster Fork Construction 5/16" steel.
Deck Thickness
10 Gauge decks with 11 gauge doubler plate
and 3/16" reinforcement plate connecting spindle housing mounts
Box-Section Reinforced Front Edge 10 ga. thick
Deck Trim Edges Solid 1" x 3/8" steel bar for reinforced trim edge & doubled plated 10 Gauge front edge.
Deck Housing Depth 5 3/16" deep, (room for high-capacity mowing)
Deck Lift Foot-operated deck height adjustment with locking pin for setting height.
Hand Operated Controls
Ignition switch, throttle lever, control levers, park brake, blade engagement switch,
choke knob, and Fuel Tank Selector Valve.
Indicators Engine warning light and hour meter for engine run time.
Cup Holder
Two cup holders molded into the left side fuel tank.
Accommodates nearly any cup size.
Cutting Height Adjustments Height adjustment in 1/4" increments from 1" to 5".
Mowing Blades
3 Heavy-duty, heat-treated, high-lift steel blades
.25" x 2 1/2" x 18.8" .25" x 2 1/2" x 20.9"
Blade Tip Speed 18,515 FPM 18,700 FPM
Blade Drive Single B-Section belt drive to all three spindles. Spring loaded take-up idler pulley.
Blade Spindles
Machined ductile iron housing, 1 3/8" diameter high carbon steel shafts
and greasable ball bearings.
Deck Suspension Four point suspension from frame by mechanical linkage with counter balance springs.
Anti-Scalp Rollers 4 Anti-scalp rollers to improve flotation in rolling and uneven terrain.
General Specifications & Capacities
Mower Model No ZSR54 ZSR60