Filter
Top Products
Important: Read complete instructions before beginning installation.
Each unit arrives ready for installation, equipped with base, glass and associated hardware.
Remove the unit from the carton. Retain the shipping carton until satisfactory inspection of the product has been
made.
Immediately upon receipt, inspect the base and other components before installing. Confirm your unit matches your
installation rough-in. Check all carton inserts for parts and hardware. Should inspection reveal any damage or defect
in any component, do not install the unit. Damage or defect to any component claimed after the unit is installed is
excluded from the warranty. Jacuzzi Whirlpool Bath's responsibility for shipping damage ceases upon delivery of the
products in good order to the carrier. Refer any claims for damage to the carrier. For definitions of warranty coverage
and limitations, refer to the published warranty information packed with the product.
Jacuzzi Whirlpool Bath
©
is not responsible for any defect that could have been discovered, repaired, or avoided by
following this inspection.
DIMENSIONS
BASE SPECIFICATIONS
Shown is 2 wall left hand base. Right hand opposite. The 3 wall base has tile flange on both sides and back.
PRODUCT WEIGHT (Base and Enclosure )
950 lb
(431 kg)
TOTAL WEIGHT/FLOOR LOADING
1266.6 lb (574.5 kg)
63.3 lb/sq. ft. (332.1 kg/m
2
)
SPECIFICATIONS
NOTE: MINIMUM WATER PRESSURE FOR THE SYSTEM IS 45 PSI WITH 3/4" HOT & COLD SUPPLY SERVICE.
48"
27-11/16"
TOP VIEW
72"
1/2" FLEXIBLE
WATER SUPPLY
HOSES UNDER
BASE
(BOTH SIDES)
AIR SUPPLY HOSE
FRONT VIEW
4-1/2"
18-11/16"
1-1/2" TILE FLANGE
6-1/2"
27-1/4"
30-1/4"
21-1/16"
2
Jacuzzi Whirlpool Bath
©
BZ00000 03/05