Filter
Top Products
OPERATION
CONTROLLER
To turn ON press ON/OFF button or turn ON water at either shower tower.
The unit will then automatically go into a preheat cycle to heat the air
transmission pipes. There will be a 5 (five) minute pause while the system
preheats. During this time both LEDs will be ON. When ready for drying,
press the ON/OFF button. Heat and air flow will rise together (only at initial
start-up). After reaching the desired flow, the temperature may be de-
creased or increased using the Temperature button. The air flow may also
be adjusted.
Note: Temperature and air flow are factory set with a predetermined heat
and air speed.
Air Jet (12)
Controller
AIR TOWER
ON/OFF
BUTTON
INCREASE
TEMPERATURE
DECREASE
TEMPERATURE
AIR FLOW LED
AIR FLOWAIR TEMPERATURE LED AIR TEMPERATURE
AIR TOWER CONTROLS
19
Jacuzzi Whirlpool Bath
©
BZ00000 03/05