Filter
Top Products
TOWERS AND DOORS INSTALLATION
STEP 12
Move the door assembly to the door post on water
tower and slide the assembly into the door post. Locate
the base of the door into the slot of serrated door
positioner that positions the hinge barrel as shown.
BOTTOM OF
DOOR FRAME
HINGE BARREL
SHOWER BASE
WATER TOWER
DOOR POST
GLASS DOOR
STEP 13
Check that the magnetic mouldings on door and air
tower overlap. Insert adjusting bolt with locking nut into
fixed nut in top cap (See below). Adjust the door with
adjusting screw until the glass is parallel with shower
base and door moulding mates with water tower mould-
ing. It may be necessary to reposition the door into
another slot (See STEP 12) which can be done without
removing door from wall post. To do so remove the
adjusting screw from wall post, lift the door slightly to
reposition. Reinsert adjusting screw and locking nut and
adjust glass door. After final adjustment, lock this
position with locking nut. Repeat for other door.
LOCKING
NUT
ADJUSTING
SCREW (12mm)
DOOR POST
HINGE
BARREL
STEP 14
Install cover cap by sliding over adjusting screw and
bracket.
COVER CAP
13
Jacuzzi Whirlpool Bath
©
BZ00000 03/05
NOTE: For 3 WALL installation continue with STEP
21 on page 16.