Filter
Top Products
STEP 9 (2 WALL ONLY)
Place the side support rail into the slot on the water tower. Place the short wall rail into the slot on the other water
tower. Rotate flat end of short wall rail flush to wall. With rails in position install hold down brackets, but do not tighten
screws. Check water towers for level. Check side support rail for level and mark on the finished wall where to attach
rail bracket. See DETAIL A. Drill 3/16" hole and secure bracket/short wall rail with screws and wall anchors provided.
Slide cover cap over rail bracket. If a tower bolt was loosened, retighten while checking the plumb of the tower. Tighten
screws on all hold down brackets.
STEP 9 (3 WALL ONLY)
Place the short wall rails into the slot on each water tower. Rotate flat end of short wall rails flush to wall. With rails
in position install hold down brackets, but do not tighten screws. Check water towers and short wall rails for level. Drill
3/16" hole and secure short wall rails to wall with screws and wall anchors provided. If a tower bolt was loosened,
retighten while checking the plumb of the tower. Tighten screws on all hold down brackets.
TOWERS AND DOORS INSTALLATION
SHORT RAIL
(1 RAIL WITH 2 WALL)
(2 RAILS WITH 3 WALL)
FLAT END
FLUSH TO WALL
SHORT WALL RAIL (2 WALL AND 3 WALL)
CENTER SUPPORT RAIL
RAIL BRACKET
WATER TOWER
DOOR POST
SIDE RAIL
COVER CAP
WATER TOWER JAMB
HOLD DOWN BRACKET
SIDE RAIL (2 WALL ONLY)
ATTACH RAIL
BRACKET TO WALL
SECURE RAIL TO
BRACKET (TURN CW
TO TIGHTEN)
MOVE COVER CAP
OVER BRACKET
DETAIL A
SIDE RAIL COVER BRACKET (2 WALL ONLY)
11
Jacuzzi Whirlpool Bath
©
BZ00000 03/05
DRILL 3/16" HOLE
ATTACH RAIL
BRACKET TO WALL
SHORT WALL RAIL MOUNTING