Filter
Top Products
www.flexible-flyer.com 11-Rev. A 1-888-350-3015
MAINTENANCE
A
t the beginning of each season and twice monthly thereafter, it is important to perform the following
maintenance inspections:
1. Tighten all nuts and bolts. Replace as needed.
2. One week after assembly, check unit for loose or missing bolts and tighten or replace if needed.
3. Check all covers designed for bolts and sharp edges and assure they are present and in good condition.
4. Inspect chains, s-hooks, brackets, eyebolts, swing bearings, hardware, etc., for proper closure and for signs of wear,
deterioration, rust and/or damage. Replace as needed.
5. Inspect swings and chains for evidence of deterioration. Replace as needed.
6. Apply oil to any moving metal fixtures.
7. Check all metal tubing and slide bed for damage and sharp edges. Replace as needed.
8. Applying a light coat of automobile wax to all metal tubing and/or wood surfaces will help protect your unit and
add to its longevity.
9. If metal tubing becomes rusted, lightly sand the rusted area and repaint using a non-lead based paint meeting the
requirements of Title 16 CFR Part 1303.
10. If slide bed is exposed to direct sunlight, always check bed to make sure it is not too hot for children to use. If the
slide bed is hot, pour cold water on the slide bed until it cools. Check slides bed periodically during use.
11. Check unit for scuffs, burrs, sharp edges and any other defects that may occur from assembly, abuse, shipping or
everyday use. Burrs and sharp edges may be filed down until smooth and covered with duct tape if necessary.
12. When it is time to dispose of this or any playground equipment, please completely disassemble unit and dispose of
it in a safe place and manner so as not to present any hazards to any individuals. All parts of this unit are recyclable.