Filter
Top Products
Operation
DANGER
An uncovered discharge opening will allow
objects to be thrown in an operator’s or
bystander’s direction. Also, contact with the
blade could occur. Thrown objects or blade
contact can cause serious injury or death.
Never operate the mower with the discharge
deector raised, removed, or altered unless
there is a grass collection system or mulch
kit in place and working properly.
The PTO switch engages the cutting blades. Be sure
that all persons are clear of mower deck and discharge
area before engaging the PTO.
1. Set throttle to “MIDWAY” position.
2. Pull the PTO engagement knob up to engage
blades.
3. Place the throttle in the “FAST” position to begin
mowing.
Note: Park brake must be disengaged before PTO is
engaged or engine will kill.
Disengaging the PTO
1. Set throttle to “MIDWAY” position.
2. Push down on the PTO engagement knob to
disengage the blades.
Stopping the Engine
1. Bring the unit to a full stop.
2. Lock drive levers in “neutral” position.
3. Engage the parking brake.
4. Disengage the PTO.
5. Move speed control lever to neutral.
6. Place the throttle midway between the “SLOW”
and “FAST” positions.
7. Allow the engine to run for a minimum of 15
seconds, then turn the ignition switch to the
“OFF” position to stop the engine.
8. Remove the key to prevent children or other
unauthorized persons from starting engine.
9. Close the fuel shut-off valve when the machine
will not be in use for a few days, when
transporting, or when the unit is parked inside
a building.
Driving the Machine
Drive Lever/Neutral Lock Latch Operation
To lock the drive levers in “neutral lock”, squeeze the
drive levers to the “neutral” position (Do Not squeeze
the drive levers all the way back as this will cause the
drive wheels to go into full reverse direction). See
Figure 5 position 1. Place thumbs on the inner lobe
of the neutral lock latches and rotate them under
the drive levers into the “neutral lock” position. See
Figure 5 position 2. Release the drive levers.
CAUTION
If the neutral lock latches are not completely
engaged the drive levers could unexpectedly
slip into the forward drive position. If the
drive levers slip into the drive position the
unit could lurch forward and cause injury or
property damage.
Be sure the drive levers are past the roller and
securely seated at the bottom of the neutral
lock latches.
To place the drive levers in the “forward” position,
slightly squeeze the drive levers while placing thumbs
on the outer thumb lobe of the neutral lock latches
(or the index nger on the front lobe) and rotate them
from under the drive levers. Slowly and carefully
release the drive levers. See Figure 5 position 3.
To place the drive levers in the “reverse” position,
squeeze the drive levers past the neutral position. See
Figure 5 position 4.
18