Filter
Top Products
Operation
The knob can be adjusted so that machine will
“track” straight ahead with the drive levers released.
PTO Engagement Control
Located on left side of control console.
To engage the blades, the knob must be pulled
toward the operator until the turnbuckle (attached
to the blade engagement idler) locks over-center. To
disengage the blades, push the knob down until the
assist arm contacts the pin on the deck.
Park brake must be disengaged before PTO is
engaged or engine will kill.
Cold Start Kit
Located on the right hand side of engine deck, below
and slightly ahead of the hydro control shield.
The cold start kit is used to ease the starting of the
unit in cold weather or when the unit has not been
operated for a period of time. The cold start kit
moves the idler pulley away from the pump belt,
releasing the tension on the belt which allows the
engine to turn over with less resistance (see Starting
the Engine section in Operation).
Pre-Start
Fill fuel tank. For best results use only clean, fresh
regular grade unleaded gasoline with an octane rating
of 87 or higher. Regular grade leaded gasoline may
also be used; however, combustion chamber and
cylinder head will require more frequent service. See
Engine Owner’s Manual.
Do Not add oil to gasoline.
Do Not overll fuel tank. Never ll the fuel tank so
that the fuel level rises above a level that is 1/2 inch
below the bottom of the ller neck to allow for fuel
expansion and prevent fuel spillage.
Make sure you understand the controls, their
locations, their functions, and their safety
requirements.
Refer to the Maintenance section and perform all the
necessary inspection and maintenance steps.
Operating Instructions
Open the Fuel Shut-Off Valve
Rotate the valve 1/4 turn counterclockwise to turn
fuel on.
Starting the Engine
Note: Operator must have PTO disengaged and
speed control lever in neutral position when starting
the engine.
Lock drive levers in neutral and engage park brake
Note: A cold weather starting kit has been added for
ease of starting in either cold weather or when the
unit has not been run for a period of time.
• To use cold start kit:
1. Pull split ring straight out the side of the unit,
and hook the ring over the lower front hydro
control shield bolt.
2. Start engine. Refer to the following guidelines
for further starting suggestions.
• To engage pump drive (disengage cold start kit):
1. Pull chain straight out from the side of the
unit until the split ring can be removed from
the bolt.
2. Slowly release tension on chain.
1. Pull out the choke control. Place the throttle
control midway between the “Slow” and “Fast”
positions. Turn the key switch to the “Run”
position.
2. Pull recoil rope to start engine. After engine
warms up, gradually push in the choke control.
Do Not run warm engine with the choke in the
“ON” position.
Note: Kawasaki engines generally need to be
“choked” even when warm.
PTO Engagement
DANGER
The rotating blades under the mower deck
are dangerous. Blade contact can cause
serious injury or kill you.
Do Not put hands or feet under the mower
or mower deck when the blades are engaged.
17