Filter
Top Products
16. GRAPPLE ATTACHMENT
INSTALLATION INSTRUCTIONS
IMPORTANT: Refer to pages 29 & 30 for instruc-
tions concerning Installing Attachment to Quick
Draw Latch Attach.
IMPORTANT: Refer to page 31 for instructions
concerning Removing Attachment from Quick
Draw Latch Attach.
A four tine, two cylinder grapple is available to fit
3860 QT bucket widths of 72, 84, 96 and 102 inches.
The bucket grapple is useful for picking up loose hay
or roughage out of stacks, stacking and transporting
hay bales, carrying silage, and cleaning up brush.
Refer to Figure 1.
Figure 1
NOTE: Optional extended length grapple tines
are available on some grapple/bucket configura-
tions. Contact Factory for further information.
Install right and left hand grapple pedestal to bucket
back using 5/8" x 5-1/2" carriage bolts, flatwashers,
and nuts. Install pedestal support using 1/2" x 5-1/2"
bolts, flatwashers, and nuts. DO NOT TIGHTEN.
Refer to Figure 2.
If your bucket has not been pre-drilled at the factory,
then you must mark center line of pedestal support
slots and center punch. Remove pedestal assembly
and drill 9/16" holes 4 places. Reinstall pedestals.
Refer to Figure 3.
Figure 2
Figure 3
36