Filter
Top Products
10. REMOVING BUCKET OR ATTACHMENT FROM
QUICK DRAW LATCH ATTACH
IMPORTANT: Refer to page 28 For instructions
concerning Quick Draw Handle Disengaged and
Engaged Positions.
CAUTION
BEFORE LEAVING THE TRACTOR SEAT,
LOWER ATTACHMENT OR LOADER BOOM
TO GROUND, STOP ENGINE, LOCK
BRAKES, RELIEVE HYDRAULIC PRES-
SURE, AND REMOVE KEY.
DO NOT STAND, WALK OR WORK UNDER
A RAISED LOADER OR ATTACHMENT
UNLESS IT IS SECURELY BLOCKED OR
HELD IN POSITION. ACCIDENTAL MOVE-
MENT OF A CONTROL LEVER/LEVERS OR
LEAKS IN THE HYDRAULIC SUSTEM
COULD CAUSE THE LOADER TO DROP, OR
ATTACHMENT TO DUMP, CAUSING
SEVERE INJURY.
OPERATING INSTRUCTIONS
To disconnect quick draw bucket or attachment from
loader, position bucket or attachment level with
ground and approximately 1" off of ground. Refer to
Figure 1. Then pull quick draw handle into the han-
dle disengaged position and lock into quick draw
notch. Refer to Figure 4, page 28.
(1) Quick draw handle.
Figure 1
Roll quick draw bucket or attachment forward and
lower to ground. Back tractor/loader away from quick
draw bucket or attachment. Refer to Figure 2. Then
roll quick draw latch attach back so quick draw han-
dle returns to the handle engaged position. Refer to
Figure 6, page 28.
NOTE: Over extension of attachment cylinders
during this operation could cause damage to
quick draw handle due to handle contacting
quick draw bucket or attachment.
If removing an attachment utilizing a third cylinder
hydraulic circuit, disconnect loader hose quick cou-
plers from attachment quick couplers. Secure and
store loader hoses on loader frame.
Figure 2
31