Filter
Top Products
6. DISMOUNTING THE LOADER
CAUTION
ALWAYS PARK LOADER WITH MATERIAL
BUCKET OR AUTHORIZED BUSH HOG
ATTACHMENT ATTACHED TO THE LOADER.
BEFORE LEAVING THE TRACTOR SEAT,
LOWER ATTACHMENT OR LOADER BOOM
TO GROUND, STOP ENGINE, LOCK
BRAKES, RELIEVE HYDRAULIC PRESSURE
AND REMOVE KEY.
DO NOT STAND, WALK, OR WORK UNDER A
RAISED LOADER OR ATTACHMENT UNLESS
IT IS SECURELY BLOCKED OR HELD IN
POSITION. ACCIDENTAL MOVEMENT OF A
CONTROL LEVER/LEVERS OR LEAKS IN
THE HYDRAULIC SYSTEM COULD CAUSE
THE LOADER TO DROP, OR ATTACHMENT
TO DUMP, CAUSING SEVERE INJURY.
DO NOT ALLOW BYSTANDERS IN LOADER
WORK AREA.
IMPORTANT: Never allow weight of tractor to be
placed on parking stands when mounting or dis-
mounting loader.
Position the tractor/loader on a hard level surface.
Raise loader boom assembly. Position the bucket
90° to the ground. Then lower the loader boom until
front edge of bucket is resting on the ground. Refer
to Figure 1.
Figure 1
Remove the two clevis pins holding the two parking
stands in the storage position. Refer to Figure 2.
1
2
(1) Clevis pin 5/8" x 4-1/2", one each side of loader.
(2) Clevis pin 5/8" x 4", one each side of loader.
Rotate the parking stands rearward into the park
position and secure using clevis pins and hairpin
cotters. Remove the two clevis pins holding lower
legs of parking stands in the retracted position.
Extend the parking stands and reinstall clevis pins to
hold lower legs in the park position. Refer to Figure 3.
(1) Clevis pin 5/8" x 4-1/2", one each side of loader.
(2) Clevis pin 5/8" x 4", one each side of loader.
(3) Lower parking stand leg extended.
Figure 3
Figure 2
23
1
2
3