Filter
Top Products
Bird Model 4391A Power Analyst
22
Perform the following steps to adjust the contact
spring.
1. Using a small flat head screwdriver, place the
flat side of the screwdriver behind the contact
bar as indicated and bend the contact bar so
that the contact rests in the center of the slot
adjacent to the element socket (Figure 16).
2. After centering the contact, bend it slightly
toward the center of the element socket bore,
so that the profile of the element contact is
visible when viewing the element socket from
the top of the socket bore (Figure 17).
3. If the contact is accidently moved too far into
the element bore, the element will not slide
into the socket. Move the contact back into the
recessed area and repeat the process.
Figure 16
Adjust Element
Contact Up
and Down
Figure 17
Adjust Element
Contact In and
Out