Filter
Top Products
GB - 9
Check Tire Pressure
Check tire pressure and adjust to the
pressure listed on tire sidewall.
Check Engine Crankcase Oil
IMPORTANT: Engine is shipped with 5W-30
oil in crankcase. Refer to Engine Manual for
detailed instructions.
Fill Engine Fuel Tank
Refer to Engine Manual for proper type and
capacity.
Check Function of all Controls
Ensure unit runs and performs properly. See
Operation on page 11.
Run-in Attachment Belt
1. Start unit in a well-ventilated area
according to Starting and Shut Off on
page 14.
2. Engage attachment clutch lever and run
attachment for about 15 minutes.
3. Stop unit, wait for all moving parts to
stop, and remove spark plug wire.
4. Adjust clutch idler according to
Attachment Clutch/Brake Adjustment on
page 24.
5. Adjust belt finger, if necessary. See
Attachment Drive Belt Replacement on
page 22.
CAUTION: Avoid injury! Explosive
separation of tire and rim parts is
possible when they are serviced
incorrectly:
• Do not attempt to mount a tire
without the proper equipment
and experience to perform
the job.
• Do not inflate the tires above
the recommended pressure.
• Do not weld or heat a wheel
and tire assembly. Heat can
cause an increase in air
pressure resulting in an
explosion. Welding can
structurally weaken or deform
the wheel.
• Do not stand in front or over
the tire assembly when
inflating. Use a clip-on chuck
and extension hose long
enough to allow you to stand
to one side.