Filter
Top Products
GB - 21
RECOIL GUARD FOAM COVER
INSTALLATION
(Figure 13)
The recoil foam cover slides over the starter
handle and attaches to the recoil guard with
Velcro.
NOTE: The recoil guard foam cover is not
necessary for operation during the non-winter
months.
IMPORTANT: When using the unit in the
winter months the cover must be installed.
The foam prevents snow from getting into the
recoil guard and freezing the recoil pawls.
IMPORTANT: Be sure to keep the recoil foam
cover clean and clear of snow and debris at
all times. See Clean Recoil Guard Foam
Cover on page 18.
SPEED SELECTOR
ADJUSTMENT
To adjust (Figure 14):
1. Disconnect adjustment pivot pin from
speed selector arm. Save hardware for
reinstallation.
2. Place the speed selector on dash panel
in the fastest forward speed position.
3. Turn the speed selector arm straight
down towards the ground as far as it will
go.
4. Thread the adjustment pivot pin along
the shift rod until it aligns with the mating
hole on the speed selector arm.
5. Connect the pivot pin to the speed
selector arm with the hardware removed
in step 1.
6. Make sure the speed selector shifts into
each speed position.
7. Check forward and reverse speeds:
a. Start unit.
b. Shift speed selector into the first
forward speed.
c. Engage the traction clutch. Unit
should move forward.
d. Stop unit.
e. Shift speed selector into first
reverse speed.
f. Engage the traction clutch. Unit
should move backward.
g. Shut off unit.
8. Adjust pivot pin on the shift rod as
necessary so unit travels forward when
speed selector is in first forward position
and travels backward when speed
selector is in first reverse position.
9. Connect the pivot pin to the speed
selector arm with the hardware removed
in step 1.
SERVICE AND ADJUSTMENTS
WARNING: AVOID INJURY.
Read and understand the entire
Safety section before
proceeding.
Figure 13
Velcro
Recoil Guard
Foam Cover
Recoil Guard