Filter
Top Products
GB - 15
3. Make sure that the traction clutch and
attachment drive clutch levers are fully
disengaged.
4. Open fuel shutoff valve.
5. Set the engine shut off switch to the
"On" position to start and operate the
engine.
6. If engine is cold, apply choke. A warm
engine requires less choking than a cold
engine. See Engine Manual for detailed
instructions.
7. Set throttle to proper starting position
8. Press starter button on engine until
engine starts.
IMPORTANT: DO NOT operate starter more
than 15 seconds per minute, as overheating
and damage can occur. (If engine does not
start, refer to Troubleshooting on page 28.)
9. Adjust choke as needed.
10. Disconnect power cord from outlet, then
starter.
11. Set throttle to Part Throttle or Slow
position for adaptation to outside
temperature or travel. Set throttle to Fast
position for normal operation.
Shut Off
1. Release both clutch levers and wait for
all moving parts to come to a complete
stop.
2. Run unit a few minutes after use to
prevent freeze-up.
3. Move throttle to STOP position.
4. Set the engine shut off switch to the "Off"
position to shut off a running engine.
USING THE BRUSH
After proper Pre-Start and Starting:
1. Select speed control position and
direction.
IMPORTANT: DO NOT overload unit capacity
by sweeping at too fast a rate.
2. Engage the traction drive clutch first.
3. Engage the attachment clutch next.
Tips for Sweeping
To clear an area, run unit in an overlapping
series of paths. For large areas, start in the
middle and sweep debris to each side, so it is
not cleared more than once.
ALWAYS direct discharge away from area to
be cleared and with direction of the wind.
Snow is best removed as soon as possible
after snow fall.
TRAVELING
To travel from one work area to another:
1. Set throttle to SLOW position or slightly
higher.
2. Press down the handlebars enough to
raise the front of the unit slightly off the
surface.
3. Engage traction clutch without engaging
the attachment drive clutch.
TRANSPORT
ALWAYS shut off engine and close fuel shut-
off when transporting unit on a truck or trailer.
Use extra care when loading or unloading
unit onto trailer or truck.
Secure unit chassis to transport vehicle.
NEVER secure from rods or linkages that
could be damaged.
DO NOT transport machine while engine is
running.
SHORT TERM
IMPORTANT: NEVER spray unit with high-
pressure water or store unit outdoors.
Run unit a few minutes after each use to free
unit of any debris.
Close fuel shut-off valve.
Inspect unit for visible signs of wear,
breakage or damage.
Keep all nuts, bolts and screws properly
tightened and know unit is in safe working
condition.
Store unit in a cool, dry protected area.
LONG TERM
Clean unit thoroughly with mild soap and low
pressure water and lubricate (see General
Lubrication on page 18). Touch up all
scratched painted surfaces.
Remove weight from wheels by putting
blocks under frame or axle.
STORAGE
WARNING: AVOID INJURY. Read
and understand the entire Safety
section before proceeding.