Filter
Top Products
GB - 11
STANDARD CONTROLS
See Figure 4 on page 10 for all Controls and
Features locations.
Dual Handle Interlock
When Attachment Clutch and then Traction
Drive Clutch are engaged, the Attachment
Clutch will remain engaged (lever down) if
released. To stop attachment, release
Traction Drive Clutch and both clutches will
disengage.
Traction Drive Clutch - Left Hand
Lever
Squeeze the Traction
Drive Clutch Lever
against the Handlebar
(1) to engage wheel
drive for propelling unit.
Release lever (2) to
stop movement.
NOTE: Traction drive clutch should be
engaged before the attachment clutch when
brushing.
Attachment Drive Clutch - Right Hand
Lever
Squeeze Attachment
Clutch Lever against
Handlebar (1) to
engage brush.
Release both clutch
levers (2) to disengage
power and apply brake
to brush.
IMPORTANT: If the belt squeals when the
attachment clutch lever is engaged, the
attachment drive may be frozen. Immediately
release the attachment clutch lever and move
the unit into a heated area to thaw.
IMPORTANT: If belt squeals when brush runs
freely, see Attachment Clutch/Brake
Adjustment on page 24.
Choke Control Knob
1. Choke Closed position: chokes off air to
engine for easier start.
2. Choke Open position: allows for normal
operation.
Gradually open choke after engine starts.
Engine Shut-Off Switch
1. Set the engine shut off switch to the On
position to start and operate the engine.
2. Set the engine shut off switch to the Off
position to shut off a running engine.
Throttle
The Throttle controls the
engine speed. To
increase or decrease the
engine speed, adjust to:
1. Fast (normal or warm
starts)
2. Part-Throttle
3. Slow (cold weather
starts)
OPERATION
WARNING: AVOID INJURY. Read
and understand the entire Safety
section before proceeding.
WARNING: To avoid injury to
hands and feet, always disengage
clutches, shut off engine, and wait
for all movement to stop before
unclogging or working on snow
brush.
Keep hands and feet away from
brush.
2
1
OL2701
2
1
OL2691
1
2
1
2
3
2
1