Filter
Top Products
© 2005 Alamo Group Inc.
1-31
MACHETE
Information Bulletin 120697 Continued from previous Page
TECHNICAL INFORMATION BULLETIN
No. 120697
This document does not authorize the repair or replacement of parts under warranty
Electrical connection:
Identify the plus (+) lead running to the solenoid for the tilt function. This solenoid is located across
the valve from the fitting you installed. Remove approximately 2 " of the outer plastic covering from the
wires coming from the solenoid. Splice one of the 18 gauge wires you provided into one of the wires.
Connect the other end of that wire to a lug on the solenoid. It makes a difference which wire runs to which
connector. Insulate any exposed wires with electrical tape.
To Valve
Note orientation
of notch in plate
Wire connector Lugs
Swing
Lift
Dipper
Tilt
Door
"C-2"
Port
"C-1"
Port
Very Important ! DO NOT use
Solenoids as handles
Steps to take to install the tilt cylinder lock valve
Hydraulic Connections
1. Remove the tilt section hose from the "C-1" Port
2. Assemble the parts as shown above.
3. Attach the hose to the fitting on Lock valve, Test and run.