Filter
Top Products
© 2005 Alamo Group Inc.
1-26
MACHETE
TECHNICAL INFORMATION BULLETIN No. 071797
Alamo Industrial ™ Technical Services Department
1502 East Walnut
Seguin, Texas 78155
830-372-2708
Models: Machete, MB21 S/N 01001 - 01108
& MB24 S/N 01001 - 01045
Date:
Jul. 17, 1997
Bulletin No:
071797
Joystick Power Cut Off Switch:
A Joystick Supply Cut Off Switch (Master Switch) can be added to the Machete in order to
eliminate the possibility of damage caused by the joystick moving while roading the machine over rough
terrain. Inadvertent movement of the controller can result in uncontrolled movement of the boom which
may result in damage to the boom rest, the tractor or other areas.
Parts needed:
Part No. Qty Description
02964028 1 Push Pull Switch, (or a locally purchased switch)
------------- 2 12 or 14 gauge wire butt connectors (furnished by installer)
------------- a/r 14 gauge wire cut to length, preferably red wire (furnished by installer)
Procedure:
1. Turn off the tractor ignition and remove the key (disable tractor to where it can only be started
when you want it started). Set parking Brake.
2. Find the RED Voltage supply wire which supplies electrical power to the Joystick.
3. Locate a suitable mounting position within easy reach of the operator, and run the two wires
from the new switch to the red power supply wire. Cutting the existing power supply wire connect the
two butt connector from the switch to the cut power supply, see drawing.
4. Operate the machine to ensure that the joystick functions will not work when switch is "OFF"
and will when switch is "ON"
This document does not authorize the repair or replacement of parts under warranty
Note: Replaces / Same as Bulletin No. 071797A
Master Switch
2 pin connector for pump solenoid
Tractor starter solenoid (brown)
Joystick connector Plug
Butt
connectors
Switched Voltage
Supply (Red)
Hook terminal Connector
Ground (Black)
Butt connectors to tractor starter solenoid
Swing
Lift
Dipper
Tilt
Door