Filter
Top Products
Assembly Section 3-10
SR20M/SR14M 10/03
ASSEMBLY
ASSEMBLY
© 2004 Alamo Group Inc.
FIGURE 15. Rear Wing Section Deflector Attachment
FIGURE 16. Rear Center Section
Deflector attachment
Front and Rear rubber-fabric Deflectors are Standard Equipment and Front and Rear Chain Guards
are optional at extra cost. One type of guard must be installed (and maintained in good repair)
except for agricultural purposes only in areas where persons, vehicles, livestock, or other property
will not be endangered by thrown objects and where such safety equipment would prevent the
mower's reasonable performance of its assigned agricultural task.
FRONT AND REAR DEFLECTORS(Standard Equipment) CHAINGUARDS(OPTIONAL EQUIPMENT
at extra cost)(FIGURES 14-17)
DANGER
3
2,4
DEFLECTORS: Front and rear Deflectors (Standard Equipment) are recommended for the average user and will
provide superior protection from thrown objects with proper operation under normal conditions. Deflectors must
be maintained in good repair or replace after no more than two inches of wear off lower edge.
FIGURE 14. Front Rubber Deflector Attachment.
Attach the Center Front Deflector Brackets
(8,9,10) to the Center Section with the bolts
1/2" x 1-1/4” (5), locknuts (4), and
flatwashers (2). Fasten the Center Section
Front Rubber Deflectors (11) (FIGURE 14)
to these brackets with bolts 3/8" x 1” (1)
locknuts (4) flatwashers (2), and
woodwasher (3).
Attach the Front Wing Deflectors (13) to the
wing sections with the bolts 1/2" x 3-1/2”
(6) Whiz Nut Flanged (7), and retaining bars
(12).
Fasten the Rear Rubber Deflectors (6,8)
(FIGURE 15 & 16) to the Center Section
and Wing Sections with 1/2" x 1-1/4” bolts
(1), locknuts (2), and retaining bars (7,9).
Note that the Center Rear Deflector is
attached to the inside of the Center Section
with 1/2" x 1” Bolts (3), Locknuts (2), and
Washer (4) see the detail in FIGURE 16.