Filter
Top Products
MAINTENANCE
MAINTENANCE
SR20M/SR14M 06/98 Maintenance Section 5-23
© 2004 Alamo Group Inc.
STEP 11
Install the second Spindle Hub assembly on the Main Housing. Check the amount of backlash present between
its Gear and the Gear on the Input Shaft. The amount of backlash between these two Gears needs to be set to the
same amount that was set on the first Gear mesh. Add or subtract Shims as required. Once this adjustment is
made, remove the Hub Cap and apply sealer as before, then reinstall on Housing. Install all eight bolts and tighten
to a torque of 31 to 34 foot pounds. FIGURE 55& 56.
The assembly should now be filled with a good grade of NLGI 000 Grease.
FIGURE 56
FIGURE 55
R 06-21-99