Alamo SR20 Brush Cutter User Manual


 
OPERATION
OPERATION
Operation Section 4-23
© 2004 Alamo Group Inc.
SR14/SR20 10/03
9.1 Starting the Tractor
The procedure to start the tractor is model specific.
Refer to the tractor operator’s manual for starting
procedures for your particular tractor. Consult an
authorized dealer if the starting procedure is unclear.
Ensure the 3-point control lever is in the lowered position
and the PTO is disengaged before starting the tractor.
9.2 Brake and Differential Lock Setting
Always disengage the tractor differential lock when turning. When engaged the differential lock will prevent or limit
the tractor from turning. During normal cutting conditions, locking the differential provides no benefit and should
not be used.
Make sure the tractor brakes are in good operating
condition. Tractor brakes can be set to operate
independently allowing single rear wheel braking action
or locked together to provide simultaneous rear wheel
braking. FOR MOST DRIVING AND MOWING
CONDITIONS, THE BRAKE PEDALS SHOULD BE
LOCKED TOGETHER TO PROVIDE THE MOST
EFFECTIVE BRAKING ACTION.
Be aware of the operating conditions. Do not operate the Tractor with weak or faulty
brakes. When operating down a hill or on wet or rain slick roads, the braking distance
increases; use extreme care and reduce your speed in these conditions. When operating
in traffic, always use the Tractor’s flashing warning lights and reduce your speed. Be
aware of traffic around you and watch out for the other guy.
WARNING!