Filter
Top Products
MAINTENANCE
MAINTENANCE
SR20M/SR14M 04/94 Maintenance Section 5-14
© 2004 Alamo Group Inc.
WARNING BE CERTAIN TO CLAMP OR SECURELY SUPPORT THE GEARBOX AND SUB-
ASSEMBLIES TO PREVENT INJURIES TO HANDS AND FEET DUE TO
INADVERTENT DROPPING OR FALLING OVER.
WARNING ALWAYS WEAR SAFETY GLASSES AND GLOVES TO PREVENT EYE AND HAND
INJURY WHEN CHISELING OR HAMMERING ON METAL COMPONENTS. HARD-
ENED METAL WILL CHIP UN-EXPECTEDLY.
WARNING AN ASSEMBLED GEARBOX IS QUITE HEAVY. USE A HOIST OR GET HELP TO
HANDLE THEM SAFELY. LIFT CAREFULLY AND PROPERLY USING YOUR LEGS TO
LIFT - NOT YOUR BACK.
NOTICE: REFER TO OPERATOR’S MANUAL FOR INSTRUCTIONS FOR PROPER
RE-ASSEMBLY ONTO THE CUTTER DECK. TIGHTEN CORRECTLY.
TOOLS NEEDED FOR DISASSEMBLY AND ASSEMBLY OF DIVIDER GEARBOX.
1
2
3
4
5
6
7
1. Caulking Gun w/Silicon 5. Torque Wrench
2. Impact Wrench 6. 3/16" Punch
3. Chisel 3/16" wide Blade 7. 10 mm & 14 mm Socket
4. Ball Pin Hammer