Alamo SR20 Brush Cutter User Manual


 
MAINTENANCE
MAINTENANCE
SR20M/SR14M 04/94 Maintenance Section 5-18
© 2004 Alamo Group Inc.
Assembly of WW75-340
STEP 1
Install the Bearing Race into the Hub cap.
STEP 2
Install the Bearing on the Output Shaft. FIGURE 33. Place the Shaft into the Hub Cap. FIGURE 34. Place the
Bearing FIGURE 35on the Shaft and carefully drive it down FIGURE 36. Replace any shims found in disassembly,
Place the Gear FIGURE 37on the Shaft so that the threads, for the Adjusting Nut, on Shaft are exposed.
FIGURE 37FIGURE 36
FIGURE 35FIGURE 34FIGURE 33