Alamo SR14 Brush Cutter User Manual


 
Safety Section 1-3
© 2004 Alamo Group Inc.
SAFETY
SR20M/SR14M 10/03
SAFETY
READ, UNDERSTAND, and FOLLOW the following Safety
Messages. Serious injury or death may occur unless care is
taken to follow the warnings and instructions stated in the Safety
Messages. Always use good common sense to avoid hazards.
(SG-2)
Si no lee Ingles, pida ayuda a alguien que si lo lea
para que le traduzca las medidas de seguridad. (SG-3)
PELIGRO!
¡LEA EL
INSTRUCTIVO!
DANGER!
Never operate the Tractor or Implement until you have read and
completely understand this Manual, the Tractor Operator’s Manual,
and each of the Safety Messages found in the Manual or on the Tractor
and Implement. Learn how to stop the tractor engine suddenly in an
emergency. Never allow inexperienced or untrained personnel too
operate the Tractor and Implement without supervision. Make sure
the operator has fully read and understood the manuals prior to
operation. (SG-4)
WARNING!
Make certain that the “Slow Moving Vehicle” (SMV) sign is installed in
such a way as to be clearly visible and legible. When transporting the
Equipment use the Tractor flashing warning lights and follow all local traffic
regulations. (SG-6)
WARNING! Operate this Equipment only with a Tractor equipped with an approved
roll-over-protective system (ROPS). Always wear seat belts. Serious
injury or even death could result from falling off the tractor--particularly
during a turnover when the operator could be pinned under the ROPS.
(SG-7)
WARNING! Do not modify or alter this Implement. Do not permit anyone to modify or alter this Implement,
any of its components or any Implement function. (SG-8)
DANGER!
BEFORE leaving the tractor seat, always engage the brake and/or set the
tractor transmission in parking gear, disengage the PTO, stop the engine,
remove the key, and wait for all moving parts to stop. Place the tractor shift
lever into a low range or parking gear to prevent the tractor from rolling.
Never dismount a Tractor that is moving or while the engine is running.
Operate the Tractor controls from the tractor seat only.
(SG-9)
WARNING!
Always maintain the safety decals in good readable condition. If the
decals are missing, damaged, or unreadable, obtain and install replace-
ment decals immediately. (SG-5)