Alamo SR14 Brush Cutter User Manual


 
Safety Section 1-8SR20M/SR14M 10/03
© 2004 Alamo Group Inc.
SAFETY
SAFETY
WARNING!
Many varied objects, such as wire, cable, rope, or chains, can become
entangled in the operating parts of the mower head. These items could
then swing outside the housing at greater velocities than the blades. Such
a situation is extremely hazardous and could result in serious injury or
even death. Inspect the cutting area for such objects before mowing.
Remove any like object from the site. Never allow the cutting blades to
contact such items. (SGM-6)
WARNING!
Mow at the speed that you can safely operate and control the tractor and
mower. Safe mowing speed depends on terrain condition and grass type,
density, and height of cut. Normal ground speed range is from 0 to 5 mph.
Use slow mowing speeds when operating on or near steep slopes,
ditches, drop-offs, overhead obstructions, power lines, or when debris and
foreign objects are to be avoided. (SGM-7)
WARNING!
Mow only in conditions where you have clear visibilities in daylight or
with adequate artificial lighting. Never mow in darkness or foggy
conditions where you cannot clearly see at least 100 yards in front and
to the sides of the Tractor and Mower. Make sure that you can clearly
see and identify passersby, steep slopes, ditches, drop-offs, over-
head obstructions, power lines, gas lines, debris, and foreign objects.
If you do not have clear and safe visibility discontinue mowing. (SGM-
11)
WARNING!
Mow at the speed that you can safely operate and control the Tractor
and Mower. Safe mowing speed depends on terrain condition and
grass type, density, and height of cut. Normal ground speed range is
from 0 to 5 mph. Use slow mowing speeds when operating on or near
steep slopes, ditches, drop-offs, overhead obstructions, power lines,
gas lines or when debris, and foreign objects are to be avoided. (SGM-
12)
WARNING!
Extreme care should be taken when operating near loose objects such
as gravel, rocks, wire, and other debris. Inspect the area before
mowing. Foreign objects should be removed from the site to prevent
machine damage and/or bodily injury or even death. Any objects that
cannot be removed must be clearly marked and carefully avoided by
the operator. Stop mowing immediately if blades strike a foreign
object. Repair all damage and make certain rotor or blade carrier is
balanced before resuming mowing. (SGM-5)
WARNING!
Avoid mowing in reverse direction when possible. Check to make sure
there are no persons behind the mower and use extreme care when
mowing in reverse. Mow only at a slow ground speed where you can safely
operate and control the tractor and mower. Never mow an area that you
have not inspected and removed debris or foreign material. (SGM-8)
WARNING!
Do not put hands or feet under mower decks. Blade Contact can result
serious injury or even death. Stay away until all motion has stopped and
the decks are securely blocked up. (SGM-9)
DANGER!
Replace bent or broken blade with new blades. NEVER ATTEMPT TO
STRAIGHTEN OR WELD ON BLADES SINCE THIS WILL LIKELY
CRACK OR OTHERWISE DAMAGE THE BLADE WITH SUBSE-
QUENT FAILURE AND POSSIBLE SERIOUS INJURY FROM THROWN
BLADES. (SGM-10)