Filter
Top Products
ASSEMBLY
INTERSTATER 02/11 Assembly Section 3-3
© 2011 Alamo Group Inc.
ASSEMBLY
PRELIMINARY TRACTOR PREPARATION
Depending on the make and model of tractor the INTERSTATER is to be mounted on, certain modifications will
be illustrated. In some cases special accessory components for the tractor will be required before assembling
the INTERSTATER. In these cases, specific mention will be made to the manufacturer, part number and
description of required accessory component.
If so equipped, remove drawbar from rear of tractor. In most cases, the main frame rear pad is attached under
the rear axle.
If so equipped, remove all objects from exterior of cab (lights, hand rails, etc.) which may interfere with mowers
when placed in the transport position. Remove all objects from right front interior of cab structure which may
interfere with mounting and operation of sectional control valve.
If so equipped, remove foot step from each side of tractor to which a mower will be mounted.
Front tractor wheels may require a wider adjustment to clear hydraulic tank and tank mounting frame.
SPECIAL TOOLS
Special tools, for installing and servicing INTERSTATER kits, are illustrated on the below. Drawings for these
tools are available on request. If desired, tools may be obtained from Alamo on a made to order basis. Prices
will be furnished on request. ASM-FL-0001
ITEM PART NO. CODE DESCRIPTION
1 701628 S Lift Frame Assembly Suspension Chain
2 701627 A Cuttershaft Bearing Puller
3 104764 A Lift Frame Alignment Pin (2)
4 104768 A Rubber bushing Support Base
5 104767 A Rubber Bushing Compression Ring
6 104765 A Rubber Bushing Expander (Ford and Kubota Tractors)
7 104766 A Rubber Bushing Expander (I.H.,Massey-Ferguson and Case Tractors)
8 104769 A Driveshaft Installation Collar
9 1047770 A Rubber Bushing Installation Plug
10 103741 A Seal Installation and Setting Tool
- 000802 S Hydraulic Pressure Gauge, 3000 PSI
A - Denotes Special Tools designed by Alamo
S - Denotes Standard Tools or Equipment available on the market