OPERATION
INTERSTATER 02/11 Operation Section 4-34
© 2011 Alamo Group Inc.
OPERATION
MOWER STORAGE
It is recommended that the mower be stored with the center section and both wings fully lowered to ground
level. If the mower is stored with the wings in the raised position, select a level area and install wing transport
braces to prevent the wings from falling BEFORE disconnecting the mower hitch from the tractor.
Properly preparing and storing the mower at the end of the season is critical to maintaining its appearance
and to help ensure years of dependable service. The following are suggested storage procedures:
• Thoroughly clean all debris off the mower to
prevent damage from rotting grass and
standing water.
• Lubricate all mower grease points and fill
gearbox oil levels as detailed in the mainte-
nance section.
• Tighten all bolts and pins to the recom-
mended torque.
• Check the mower for worn and damaged
parts. Perform repairs and make replace-
ments immediately so that the mower will be
ready for use at the start of the next season.
• Store the mower in a clean, dry place with
the mower housing resting securely on
blocks or at ground level.
• Keep the driveline yoke from sitting in water,
dirt and other contaminants.
• Use spray touch-up enamel where neces-
sary to prevent rust and maintain the appear-
ance of the mower.
It is critical that driveline clutches slip when an obstacle or heavy load is encountered to avoid mower and/or
tractor damage. If the mower sits outside for an extended period of time or is exposed to rain and/or humid
air, the clutch lining plates must be inspected to ensure they are not frozen together from rust or corrosion. If
the mower has been exposed to such conditions, at the start of each mowing season, and any time it is
suspected that the slip clutch plates may be frozen together, readjust the slip clutch as detailed in Seasonal
Clutch Maintenance of the maintenance section in this manual. OPS-F-0014
Never allow children to play on or around Tractor or Implement. Children can slip or fall off
the Equipment and be injured or killed. Inadvertent contact with controls can cause the
Implement to shift or fall crushing themselves or others.
(SG-25)