Filter
Top Products
42 Chapter 2
Basic Operation
Configuring the RF Output
3. Use the arrow keys to highlight the dwell time in row 1.
4. Press
Edit Item.
The dwell time for point 1 becomes the active function.
5. Press
100 > msec.
This enters 100 ms as the new dwell time value for row 1. Note that the next item in the table
(in this case, the frequency value for point 2) becomes highlighted after you press the terminator
softkey.
6. Using the arrow keys, highlight the frequency value in row 4.
7. Press
Edit Item > 545 > MHz.
This changes the frequency value in row 4 to 545 MHz.
8. Highlight any column in the point 7 row and press
Insert Row.
This adds a new point between points 7 and 8. A copy of the point 7 row is placed between
points 7 and 8, creating a new point 8, and renumbering the successive points.
9. Highlight the frequency item for point 8, then press
Insert Item.
Pressing
Insert Item shifts frequency values down one row, beginning at point 8. Note that the
original frequency values for both points 8 and 9 shift down one row, creating an entry for point
10 that contains only a frequency value (the power and dwell time items do not shift down).
The frequency for point 8 is still active.
10. Press
590 > MHz.
11. Press
Insert Item > -2.5 > dBm.
This inserts a new power value at point 8 and shifts down the original power values for points 8
and 9 by one row.
12. Highlight the dwell time for point 9, then press
Insert Item.
A duplicate of the highlighted dwell time is inserted for point 9, shifting the existing value down
to complete the entry for point 10.
To Configure a Single List Sweep
1. Press Return > Sweep > Freq & Ampl
This turns the sweep on again. No errors should occur if all parameters for every point have been
defined in the previous editing process.
2. Press
Single Sweep.
The signal generator will single sweep the points in your list. The SWEEP annunciator activates
during the sweep.
3. Press
More (1 of 2) > SweepTrigger > Trigger Key.
This sets the sweep trigger to occur when you press the
Tri gg er hardkey.
4. Press
More (2 of 2) > Single Sweep.
This arms the sweep. The ARMED annunciator is activated.