Filter
Top Products
Chapter 3 87
Basic Digital Operation
Using the Dual ARB Waveform Player
Bandwidth softkey sets the bandwidth over which the noise is integrated and the Noise Bandwidth Factor
softkey allows you to select a flat noise bandwidth. These softkeys are described in the E8257D/67D
PSG Signal Generators Key Reference.
The following procedure sets up a carrier and modulates it using the pre-defined SINE_TEST_WFM
waveform file. AWGN is then applied to the carrier.
Configuring AWGN
1. Preset the signal generator. Press the
Preset hardkey.
2. Press the
Frequency hardkey and enter 15 GHz.
3. Press the
Amplitude hardkey and enter –10 dBm.
4. Press
RF On Off to On.
5. Press
Mode > Dual ARB > Select Waveform and select the SINE_TEST_WFM waveform.
6. Press
Select Waveform.
7. Press
ARB Off On to On.
8. Press
ARB Setup > ARB Sample Clock enter 50 MHz.
9. Press
Real-time Noise Setup > Carrier to Noise Ratio and enter 30 dB.
10. Press
Carrier Bandwidth and enter 40 MHz.
11. Press
Real-time Noise Off On to On.
This procedure applies AWGN to the 15 GHz carrier. The displayed power level of the signal
generator, –10 dBm, will include the noise power which is set as a carrier to noise ratio (C/N) of
30 dB. Noise power, for the purpose of C/N, is applied across a carrier bandwidth of 40 MHz. The
default noise bandwidth factor is 1, which provides a flat noise signal bandwidth of a least 0.8 times
the 50 MHz sample rate.
Storing and Loading Waveform Segments
Waveform segments can reside in volatile memory as WFM1 files, or they can be stored to
non-volatile memory as NVWFM files, or both. To play or edit a waveform file, it must reside in
volatile memory. Because files stored in volatile memory do not survive a power cycle, it is a good
practice to store important files to non-volatile memory and load them to volatile memory whenever
you want to use them.
Storing Waveform Segments to Non-volatile Memory
1. Press
Mode > Dual ARB > Waveform Segments.
2. If necessary, press
Load Store to Store.
3. Press
Store All To NVWFM Memory.
Copies of all WFM1 waveform segment files have been stored in non-volatile memory as NVWFM
files. To store files individually, highlight the file and press
Store Segment To NVWFM Memory.