Filter
Top Products
55
Screen 3.5 “Information“
In the screen “Information” you can check the UPS configuration of the unit.
Configuration and status of the unit:
• “Single” Single connection.
• “Parallel-Single” parallel connection. Unit is in “single” state.
• “Parallel-Master” parallel connection. Unit is in “master” state.
• “Parallel-Slave” parallel connection. Unit is in “slave” state.
Internal firmware versions of both Digital Signal Processor (“DSP Ver:”) and
micro controller (“uC Ver:”).
UPS Serial Number, expressed with 10 characters.
Service information in the basic settings should be used.