Filter
Top Products
23
If these sections should have to be changed for any reason, this should be
implemented with a separate distribution box and the sections indicated should
be maintained from the device to the distribution box.
In standard equipment up to 40 kVA, batteries are supplied inside the UPS
enclosure and for higher power rates they are supplied in a separate cabinet. By
default, the UPS has a battery fuse-holder switch (Q3) with 3 fuses for models up
to 40 kVA or battery switch (Q3) for models with higher power rate.
From 60 kVA upwards, no UPS internal batteries are installed, instead you will find
a circuit breaker (Q8) in the battery cabinet. Fuses are includes in the delivery of
the UPS. Open the fuse box (Q3) and (Q8) and install the three fuses. Connect the
battery with the UPS and then follow the startup procedure prompted via the UPS
display.
IMPORTANT FOR YOUR SAFETY: Do not turn the battery fuse holder switch or
switch (Q3) located in the equipment or its equivalent (Q8) in the battery cabinet
to “On” (Close) until the equipment is switched on completely, because it can
cause irreversible damage to the equipment or accidents.
4.2. SET UP AND INSTALLATION
4.2.1. UNPACKING AND CONTENT CHECKING
On receiving the device, make sure that it has not suffered any damage during
transport. Make all damage claims to your supplier or to our company. Check
the data in the nameplate, which is fixed inside the front door (PF) and that it
corresponds to that specified in the purchase order. To check this, it will be
necessary to unpack the UPS. If this is not possible, any non-conformity must
be sent at the earliest possible date, quoting the device manufacturing number
and any references on the delivery remittance.
When the device has been accepted, it is best to pack the UPS away once more
until it is to be commissioned in order to protect it from any possible mechanical
knocks, dust, dirt, etc.
The packaging of the device consists of a wooden pallet, a cardboard or wooden
surround (depending on the case), expanded polystyrene corner pieces,
polyethylene sleeve and band. All are recyclable materials and should therefore
be disposed of according to current regulations. However, we recommend that
the packaging should be kept in case its use is necessary in the future.
To unpack, cut the bands on the cardboard surround and remove it from above.