Filter
Top Products
62
MULTI MODE
Operation
1 Select the desired note number and its assigned drum sound with
the PART q buttons.
For a list of the available sounds and their note assignments, see
the SOUND LIST & MIDI DATA booklet.
HINT
You can also select the desired note number by simply pressing the appropriate key on a
connected MIDI keyboard.
2 Select the desired parameter with the SELECT w buttons.
Refer to the descriptions below for details on the individual pa-
rameters.
3 Change the parameter value with the VALUE q buttons.
Drum Setup Parameters
Pitch Coarse
Range: –64 … +63
This determines the coarse pitch setting of the selected drum sound.
This parameter is only available when the Part Mode has been set to
DrumS1 … S4. (See page 54.)
Pitch Fine
Range: –64 … +63
This determines the fine pitch setting of the selected drum sound.
Level
Range: 0 … 127
This determines the volume of the selected drum sound.
Pan
Settings: Rnd (Random), L63 … C … R63
This determines the stereo position of the selected drum sound. A
setting of “Rnd” (Random) randomly assigns the drum to a pan po-
sition. This is useful when you want to have different drums sound
from different random parts of the stereo image.
Reverb Send (Rev Send)
Range: 0 … 127
This determines the level of the selected drum sound that is sent to
the Reverb effect. A value of 0 results in a completely “dry” drum
sound, no matter how much Reverb is applied to the Drum Part.