Yamaha MU80 Portable Generator User Manual


 
APPENDIX
123
All Notes Off: 7BH
Cntrl# Parameter Data Range
123 0
Switches off all currently “on” notes in all parts. Any notes being held by sustain or sostenuto
continue to sound until sustain/sostenuto goes off.
OMNI Off: 7CH
Cntrl# Parameter Data Range
124 0
Same processing as for All Notes Off.
OMNI On: 7DH
Cntrl# Parameter Data Range
125 0
Same processing as for All Notes Off. (“OMNI ON” operation not supported.)
MONO: 7EH
Cntrl# Parameter Data Range
126 Mono 0 to 16
Generates “All Sound Off” operation. If the value of the third byte (mono number) is 0~16,
the channel changes to Mode 4 (m=1).
POLY: 7FH
Cntrl# Parameter Data Range
127 0
Generates “All Sound Off” operation, and sets the channel to Mode 3.
5. Channel Aftertouch
Status: DnH
The message is not effective under initial settings to enable use of this message, send system
Exclusive to change the channel aftertouch (CAT) parameters.
If multipart parameter “Rcv CHANNEL AFTERTOUCH” is Off, the part ignores this
message.