Filter
Top Products
Troubleshooting Reference
975-0057-01-01 5-5
The
compressor
runs but won’t
inflate
(XPower
Powerpack
400 Plus only).
The valve connector
may not be securely
placed on the valve
stem.
The item being
inflated may have a
leak.
Check that the valve connector is
securely placed on the valve stem
before closing the thumb latch.
Check that the item being inflated
has no leaks.
Check the compressor hose for any
breaks or leaks at connections.
The
compressor
runs slowly
(XPower
Powerpack
400 Plus only).
The compressor may
have overheated from
excessive use.
Battery voltage is too
low.
Turn off the compressor and let it
cool down.
Check the condition of the internal
battery. The battery may need to be
recharged or replaced.
The engine
being jump-
started will not
start.
XPower Powerpack
battery is not fully
charged.
The engine condition
is poor.
External fuse (250 A)
is blown.
The engine start
capacity exceeds the
XPower Powerpack
jump-start capability.
Recharge the XPower Powerpack
battery.
Have the engine serviced.
Replace 250 A, 32 V fuse with same
type and ratings.
Table 5-1
Troubleshooting reference
XPower 400 Powerpack Plus.book Page 5 Thursday, October 20, 2005 12:58 PM